5:13 am
April 12, 2010
2:55 pm
September 7, 2010
4:09 pm
March 22, 2010
7:14 am
June 1, 2010
7:59 am
March 22, 2010
Ok...... Its not much to see.... but I did as ask..
Whatever you are, be a good one.
Abraham Lincoln
1:59 pm
May 13, 2010
4:39 pm
March 21, 2011
8:29 pm
May 13, 2010
ianinsa;12339 wrote: Larry,
John,
I'd Be keen to see your die'sIan
Turns out I was aggressive enough with the pricing that I didn't get the bending job, my customer didn't get the job. It would have been a nice job to get at the premium price to but I don't mind being able to take part of this afternoon off and not pissing off my other customers.
I will drag the jig off the high shelf one day next week and snap some pictures. It is not really anything special just a plate with a bunch of holes in it.
10:45 am
May 18, 2010
Hi John
We no longer do many points or chisels or wide chisels either, but I just taper the ashphalt cutters or wide chisels on plain dies, give them a quick run over with a roundback to smooth the hammer marks out then we grind the edge back to where it should be and put an edge on it all with our linisher. If we charge $5.00 each for points and chisels we charge about $7.50 to $8.00 each for a wide chisel.
Most Users Ever Online: 668
Currently Online:
17 Guest(s)
Currently Browsing this Page:
1 Guest(s)
Top Posters:
Larry L: 1566
Grant: 1420
Bruce Macmillan: 625
Lee Cordochorea: 595
Lynn Gledhill: 572
JNewman: 520
Gene C: 504
J Wilson: 426
Eric Sprado: 383
Tom Allyn: 340
Member Stats:
Guest Posters: 22
Members: 8710
Moderators: 4
Admins: 1
Forum Stats:
Groups: 23
Forums: 97
Topics: 3532
Posts: 20280
Newest Members:
Lionel42, briana2211, LawlessForge, Jim Cameron, hsmac02, Theresa Mae Oborn, Anthony Parker-Hoang, PJF, Adamphipps, JackstakesModerators: Steve McGrew: 77, N.W.B.A.: 72, webmaster: 0, bluehost: 0
Administrators: admin: 539