diamond pattern

[Bruce Macmillan]

made from 3/4''.........

[sam salvati]

Nice threaded rod mod! Surprised it didn't come apart.

[D_Evans]

Is that really made from all-thread?

[Bruce Macmillan]

Is that really made from all-thread?

Galvanized allthread at that.......Here's another that Rory May showed me....I think it would make a cool handle for a dagger or knife, get on it Sam...

[sam salvati]

Yeah it would, very cool! Have to forge weld on a good bit of steel for the blade though

[Bruce Macmillan]

Yeah it would, very cool! Have to forge weld on a good bit of steel for the blade though

I bet I could coax a 5/16'' hole through a 4'' piece in the lathe, chucking up would be bitchy but not impossible.........Then use whatever for the blade.

[sam salvati]

yeah that'd be cool too, you could even thread a section of high carbon round bar then forge the blade too.

[John Bellamy]

yeah that'd be cool too, you could even thread a section of high carbon round bar then forge the blade too.

Hows about a high tensile steel bolt or set screw to start with Sam

Even got a pommel on already

[Bruce Macmillan]

Hows about a high tensile steel bolt or set screw to start with Sam

Even got a pommel on already

Yeah, hows bout'....... grind away the threads on each side of the blade and leave em on the edges so it would serrated............. Wicked........Rambo would buy one.....

• 

[David Kunkler]

I bet I could coax a 5/16'' hole through a 4'' piece in the lathe, chucking up would be bitchy but not impossible....

A split piece of CPVC pipe would do the trick.