3:20 pm
NWBA Member
April 21, 2010
Greetings to the membership, the following is the thread mentioned in the Three Scroll Trivet article in the third quarter 2011 issue of the HIN. I would like to apologize for not getting this up on an earlier date. The full sized jig is posted below in a PDF format. Print the jig on standard printer paper, then bend the flat bar into shape to mach the drawing.Then weld the jig to a length of angle iron so you can clamp it in your vice. Thank you for your patience.
Respectfully
Ben Czyhold
Most Users Ever Online: 668
Currently Online:
17 Guest(s)
Currently Browsing this Page:
1 Guest(s)
Top Posters:
Larry L: 1566
Grant: 1420
Bruce Macmillan: 625
Lee Cordochorea: 595
Lynn Gledhill: 572
JNewman: 520
Gene C: 504
J Wilson: 426
Eric Sprado: 383
Tom Allyn: 340
Member Stats:
Guest Posters: 22
Members: 8729
Moderators: 4
Admins: 1
Forum Stats:
Groups: 23
Forums: 97
Topics: 3538
Posts: 20289
Newest Members:
TruSteele13, windhaen, Jeffrey Funk, Tom, churndashmaven, cameliacity, fred.f.chopin, RuoYi, rodeoneerer, NWBABjornModerators: Steve McGrew: 77, N.W.B.A.: 72, webmaster: 0, bluehost: 0
Administrators: admin: 540