4:03 pm
NWBA Member
February 21, 2019
I have a few tools. I'd like to add a ball punch to arsenal. My thought is to use a ball-peen hammer head, leaving the ball end hard while softening the hammer end (so it can be safely struck by another hammer). This must have been done many times before, but I'm not finding a how-to. So... does someone with some heat-treating knowledge have a process for this? Is it as straight-forward as torching the hammer end to a purple color, say?
Thanks!
11:25 am
NWBA Member
Board Member
April 26, 2010
Put the ball in a container of water* & torch the flat until it glows. Allow to cool slowly. TEST WITH FILE to insure success before hitting softened end.
*Make sure there's enough water. One way is to clamp the hammer head to a bar & dangle the ball into the slack tub.
That simple.
No matter where you go... there you are.
Most Users Ever Online: 668
Currently Online:
31 Guest(s)
Currently Browsing this Page:
1 Guest(s)
Top Posters:
Larry L: 1566
Grant: 1420
Bruce Macmillan: 625
Lee Cordochorea: 595
Lynn Gledhill: 572
JNewman: 520
Gene C: 504
J Wilson: 426
Eric Sprado: 383
Tom Allyn: 340
Member Stats:
Guest Posters: 22
Members: 8726
Moderators: 4
Admins: 1
Forum Stats:
Groups: 23
Forums: 97
Topics: 3538
Posts: 20289
Newest Members:
Tom, churndashmaven, cameliacity, fred.f.chopin, RuoYi, rodeoneerer, NWBABjorn, mddangelo, Nevillberger, Crusty VeteranModerators: Steve McGrew: 77, N.W.B.A.: 72, webmaster: 0, bluehost: 0
Administrators: admin: 540